Seagate HDD SATA Reset but Long to Be Ready

This is one very common Seagate F3 hard drive firmware repair and data recovery case study.

Patient HDD Symptom:

In the com terminal, the drive outputs SATA reset and it shows the drive doesn’t have major firmware corruption but the problem is that the patient hdd doesn’t get ready and users need to wait for a long time to be ready.

For this kind of case, users need to be very patient with the patient hdd, users need to enter the main firmware repair software interface, sometimes, users need to manually select hdd family or need to use boot mode to read hard drive ID from the PCB.

After the patient hdd gets ready, users can unlock the firmware area and backup important SYS files or backup important sys files directly.

Next users just need to disable vacant active and turn off the media cache and then power off and on the patient HDD, the patient HDD will be perfectly fixed. If this kind of simple repair can fix the patient HDD failure, users don’t need to regenerate translator.

Any question is welcome to [email protected] or add Dolphin skype ID: dolphin.data.lab